Knowledgebase

 
 
Knowledgebase Article
Knowledgebase > Unified Communications > SmartNode > ATA (Analog Telephone Adapter)


Configure a Patton M-ATA with Avaya IP Office Platform 9.1
Article Id #: 461

Please follow these instructions to setup your Patton M-ATA as a SIP Extension within the Avaya IP Office Platform 9.1.

 

A.  Either enable Auto-Create Extn/User or otherwise manually add SIP extensions and users to the IP Office configuration.

1. Browse to the IP address of the Micro ATA.

2. Login and select SIP.

3. Enter the values to match the settings of the IP Office LAN on which the SIP Registrar is enabled. Click Save.

4. Select CODECS.

5. Set the codecs to match those set for the IP Office SIP extension. Click Save CODEC Configuration.

6. Select Phone 1.

7. Enter the values to match the IP Office SIP extension and user settings. Click Save.

B.  If installed using extension and user auto-creation, check the settings of the IP Office SIP extension and user created by the SIP devices registration.

C.  Make test calls from and to the SIP device.

D.  If not installing any further SIP devices, Disable Auto-Create Extn/User if it is enabled.

 

For more information, please read the Avaya document here.

User Rating
This answer was helpful This answer was not helpful (168 vote(s)) 
User Comments  Add a Comment )

 
 
 
Sales: sales@patton.com
Direct: +1 301 975 1000
Support: support@patton.com
Direct: +1 301 975 1007
Have Us Contact You
or
Login Connect with us
Twitter Linkedin Facebook Youtube
 
     Copyright © 2001–2017 Patton Electronics Co., All Rights Reserved.

|  Sitemap  |   Legal  |   Privacy Policy  |   Disclaimer  |    Twitter  Facebook  YouTube  LinkedIn  RSS