Knowledgebase

Configuration Description

The command sequence below enables static-IP-addressing by assigning a fixed IP address, netmask, and default gateway address to a SmartNode IP interface.

To complete this configuration you will need the following information:

The IP-Address and network mask for the SmartNode: [IF-IP], [IF-MASK]
The Gateway address of the default gateway:[GW-IP]

Use the command "show ip route" to display the routing table.

10.10.22.53(ctx-ip)[router]#show ip route
Route Table of IP context 'router':
Validity state (V): * valid, (*) duplicate Flags: U up, H host, G Gateway, L local, D default
--------------------------------------------------------------
V Destination Nexthop Protocol Metric Flags
--------------------------------------------------------------
* 10.10.22.53/32 loopback local 0 ULH
* 192.168.2.1/32 loopback local 0 ULH
* 127.0.0.1/32 loopback local 0 ULH
* 192.168.2.0/24 eth1 local 1 UL
* 10.10.0.0/16 eth0 local 1 UL
* 127.0.0.0/8 loopback local 1 UL
* 0.0.0.0/0 10.10.1.10 static 0 UDG
(*) 0.0.0.0/0 10.10.1.1 dhcp 12 DG
--------------------------------------------------------------

Command Sequence to copy, edit and paste

context ip
interface [IF-NAME]
ipaddress [IF-IP] [IF-MASK]

context ip
route 0.0.0.0 0.0.0.0 [GW-IP]