Knowledgebase Article
| Knowledgebase > Unified Communications > SmartNode > SmartWare |
|
||
| How do I configure the IGMP functionalities ? | |||
| Article Id #: 135 | |||
If you want route a multicast stream, you need to configure this on the ethernet interfaces. There are two commands, one for the sending interface (to the clients) and the other for the receiving interface (eg. from the WAN). interface IF_IP_WAN ipaddress 192.168.1.20 255.255.255.0 icmp router-discovery igmp interface-type proxy-upstream interface IF_IP_LAN ipaddress 10.0.0.1 255.255.255.0 icmp router-discovery igmp interface-type proxy-downstream Note: On interface IF_IP_LAN there are the receiving units connected, therefore the SmartNode must send the stream out there (downstream). Interface IF_IP_WAN is the receiving interface (upstream). |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8772 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
