Knowledgebase

 
 
Knowledgebase Article
Knowledgebase > Unified Communications > SmartNode > SmartWare


How do I install a license key?
Article Id #: 137
License Key installation is described in the Software Configuration Guide 3.10 in the Chapter "Basic System Management" section "Managing Feature License Keys".

To install the licenses, simply copy the install command and license key ("install license 00010001gB...") from this message and paste them into an open CLI telnet or console session. Note that the CLI session must be in the "configure" mode.
You can verify that your license are installed using the following command:
  show licenses

Occasionally, e-mail clients can add spaces or tabs that will currupt a license key. If you have problems with the cut and paste method, you can alternatively copy a license file from your TFTP server as follows:
  copy tftp://tftp-server-ip-address/tftp-server-path/license-file licenses:

Example:
 copy tftp://192.168.1.1/sn4xxx_00a0ba001234.lic licenses:

  You should then see:
  Download...100%
User Rating
This answer was helpful This answer was not helpful (1764 vote(s)) 
User Comments  Add a Comment )

 
 
 
Sales: sales@patton.com / +1 301 975 1000
Support: support@patton.com / +1 301 975 1007
Join Our Email List
Have Us Contact You
or
Login Connect With Us
Twitter Linkedin Facebook Youtube
 
     Patton Electronics Co. Copyright © 2001–2020 All Rights Reserved.

|  Sitemap  |   Legal  |   Privacy Policy  |   Disclaimer  |    Twitter  Facebook  YouTube  LinkedIn  RSS