Knowledgebase Article
| Knowledgebase > Unified Communications > SmartNode > SmartWare |
|
||
| How can I do Call Transfer and FLASH codes on the SmartNode? | |||
| Article Id #: 154 | |||
SmartWare FLASH Codes -FLASH 0 - keep current, reject incoming -FLASH 1 - drop current, accept incoming -FLASH 2 - hold current, accept incoming To toggle between the active and the held call, press flash-hook, followed by the "2" key. Additional Call Offering To enable aditional call offering, configure the fxs port of the SN with the command: additional-call-offering 1) Press FLASH, then the first call is placed on hold and you will hear a new dial tone. 2) Dial the number of the second call. 3) If you press FLASH, you may change between the two calls. 4) When you hang-up on the phone, the two other parties are connected together. Sorry, three way conferencing is not yet supported. |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8829 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
