Knowledgebase

Configuration Description

Port and context ip configuration for a ADSL PPPoEoA (point to point over Ethernet over ATM) link over a SmartNode VoIP-Gateway.

This example is for SmartNode models using the ADSL interface which is indicated by "/A" in the product SKU.

In case a PPPoA (point to point over ATM, without Ethernet layer) is required, please see the corresponding article. Link to PPPoA article.

Commande Sequece to copy, edit and paste

#----------------------------------------------------------------#
#                                                                #
# SN465X / SN485X / SN467X ADSL-VOIP-GATEWAY                     #
#                                                                #
# Sample-Configuration, including the IP-Router                  #
#                                                                #
# Please replace all variables before you are using this         #
# configuration.                                                 #
#                                                                #
# Author: MA, Patton-Inalp Netowrks, CH-3172 Niederwangen        #
# Date: 2014-06-27                                               #
#                                                                #
#----------------------------------------------------------------#

profile napt NAPT_WAN

profile ppp default

context ip router

  interface IF_WAN
    ipaddress <set your ip-addres and ip-mask or use unnumbered>
    mtu 1492
    point-point
    use profile napt NAPT_WAN
    tcp adjust-mss rx mtu
    tcp adjust-mss tx mtu

context ip router
  route 0.0.0.0 0.0.0.0 IF_WAN 0

subscriber ppp SUB_ADSL_1
  dial out
  authentication chap
  identification outbound <ADSL-Username> password <ADSL-Password>
  bind interface IF_WAN router

port dsl 0 0

annex <set the annex to be used; [a|b|m]>

  pvc-ethernet vpi <set your vpi number> vci <set your vci number>

    pppoe

      session SES_ADSL
        bind subscriber SUB_ADSL_1
        no shutdown