Configuration Description
A Simple Asterisk Registration into PBX T1 on Port 0 0## Replace ‹0.0.0.0› with IP address or dns name of the registrar, e.g. 192.168.1.1# Replace ‹XXX› with account, e.g., 1234# Replace ‹YYY› with account password, e.g., mysecret# Replace < ethernet-interface > with the ethernet interface you use## Example configuration is based on firmware 5.X, for SN4940, SN4950 and SN4960
Command Sequence to copy, edit and paste
profile voip VOIP-ASTERISK
codec 1 g729 rx-length 20 tx-length 20
codec 2 g711ulaw64k rx-length 20 tx-length 20
codec 3 g711alaw64k rx-length 20 tx-length 20
context cs switch
routing-table called-e164 RT_PSTN_TO_SIP
route .T dest-interface IF_SIP
interface isdn IF_ISDN_00
route call dest-table RT_PSTN_TO_SIP
interface sip IF_SIP
bind context sip-gateway GW_SIP
# Enter below the SIP server / Softswitch IP address or FQDN
remote <0.0.0.0>
route call dest-interface IF_ISDN_00
# Enter below the SIP username, to be used as user part in from header
address-translation outgoing-call from-header user-part fix <username> host-part call
context cs switch
no shutdown
authentication-service AUTH_SVC
# Enter below the username and passwort you got by VOIP provider
username [XXX] password [YYY]
location-service LOCATION_SVC
# The line below requires the VOIP Providers domain name
domain 1 [registrar IP or domain]
# Set the SIP username on the line below
identity <username>
authentication outbound
# Replace the XXX with the username of Authentication service
authenticate 1 authentication-service AUTH_SVC username <username>
registration outbound
# Set the Registrar IP or domainname of VOIP provider
registrar 1 <IP or Domain>
register auto
context sip-gateway GW_SIP
interface IF_GWSIP
bind interface WAN context router port 5060
context sip-gateway GW_SIP
bind location-service LOCATION_SVC
no shutdown
port t1 0 0
clock auto
encapsulation q921
q921
protocol pp
uni-side auto
encapsulation q931
q931
protocol ni2
uni-side user
encapsulation cc-isdn
bind interface IF_ISDN_00 switch
port t1 0 0
no shutdown
This answer was helpful
This answer was not helpful
