| Knowledgebase > Unified Communications > SmartNode > SmartWare |
|
||
| SN - Example config for Voxbone inbound call service | |||
| Article Id #: 329 | |||
This article describes how to configure a Patton SmartNode with Voxbone International Inbound SIP Trunking service, which provides Telephone numbers (DID) and toll-free numbers in 50+ countries and 4000+ area codes which can be configured to ring on the Patton SmartNode VoIP Gateway anywhere in the world. Please note that Voxbone ONLY supports inbound calls (local TDM via VoIP to SmartNode equipped customer site) Config for Analogue SmartNode (FXS) Config for Analogue SmartNode (FXO) ** Note that the above conifgs are using an ACL profile as well as a trusted host command in the SIP interface. This is to protect your SmartNode from any attacks incoming from outside sources. It is not recommended to put the SmartNode on a public address without this protection enabled. For more information on ACL rules and any configuration parameter, please refer to our Software Configuration Guide.
For more details on configuration, see the application note for the Voxbone service. |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8780 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
