Knowledgebase Article
| Knowledgebase > Connectivity > CopperLink |
|
||
| Adding a default gateway to the CopperLink 2160 management port. | |||
| Article Id #: 385 | |||
1) Console or Telnet into the unit and login. 2) Click on "enable" and enter Supervisor password with is "root" by default. 3) Go to "setup". 4) Go to “bridge” 5) Enter the Gateway address here 6) Go back to the main screen and go to “write” 7) Save the config and reboot the unit. The unit will now have a default gateway specified for the 2160. |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8755 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
