Knowledgebase Article
| Knowledgebase > Unified Communications > SmartNode > SmartMedia > SN10K |
|
||
| Cannot receive calls on SmartNode when PRI port is using the DMS-100 protocol. | |||
| Article Id #: 406 | |||
When the SmartNode receives an incoming SETUP message from the PRI port, it returns a SETUP ACKNOWLEDGEMENT and then the connecting switch sends back a "Cause : message type not compatible with call state". This is due to the fact that the DMS-100 implementation doesn't support overlap-sending, which is what is causing this SETUP ACK to be sent out. To correct this, the following command needs to be entered in the ISDN interface to disable this behavior.
address-complete-indication accept set
Once this is set in the interface, the SmartNode will no longer send out the SETUP ACK.
|
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8777 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
