| Knowledgebase > Internal Knowledge Base |
|
||
| Patton Trinity SmartNode configuration with 3CX | |||
| Article Id #: 478 | |||
Patton SmartNode gateways running SmartWare can easily be configured and provisioned from within the 3CX Phone System.� Just select the model from the drop-down and fill in the necessary parameters, load it in the SmartNode and you are ready to start making and receiving calls.� This is great, but what if you have a new Patton SmartNode running Trinity?� How do you configure it like any other SmartWare SmartNode device in 3CX? Don't waste any more time thinking about it as Patton just made it�easy for you to accomplish this.� Patton has created new templates that are available to download and install into your 3CX Phone System.� Just a few�simple steps and you will be configuring your Trinity SmartNode devices in no time at all. Supported Products: Trinity BRI SmartNodes (1-4 ports) Trinity E1/T1 SmartNodes (1-4 ports) Trinity FXO SmartNodes (1-8 ports) Trinity FXS SmartNodes (1-8 ports). Instructions to load Trinity Templates into 3CX (WINDOWS)
The template files are now added to the following Windows directories for your 3CX Phone System: C:\ProgramData\3CX\Instance1\Data\Http\Templates\gateway Instructions to load Trinity configurations into SmartNodes
� �
Your SmartNode will now be successfully configured and registered to use 3CX. Please contact Patton Support if you have any questions. [email protected]Note From 3CX on Templates:  |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8797 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
) from the upper left-hand side
