Knowledgebase

 
 
Knowledgebase Article
Knowledgebase


Hotline configuration
Article Id #: 482
With the following configuration snippet the SmartNode will wait 12 seconds* and change the called party number if nothing was dialed.

First the call has to be routed to the RT_HOTLINE table. There the timeout will wait  by default 12 seconds and route the called forced to the specified interface (or table, or service).
The 12 seconds can be configured in "context cs SWITCH" using the "address-completion timeout".

During the routing the SmartNode will evaluate the configured mapping-table, which changes the number to the hotline number (12345 in the example) if no number was dialed.

routing-table called-e164 RT_HOTLINE

  route T!5 dest-interface <target interface> MT_CALLED_HOTLINE

mapping-table called-e164 to called-e164 MT_CALLED_HOTLINE

  map ^$ to 12345

User Rating
This answer was helpful This answer was not helpful (1626 vote(s)) 
User Comments  Add a Comment )

 
 
 
Sales: sales@patton.com
Direct: +1 301 975 1000
Support: support@patton.com
Direct: +1 301 975 1007
Have Us Contact You
or
Login Connect with us
Twitter Linkedin Facebook Youtube
 
     Copyright © 2001–2019 Patton Electronics Co., All Rights Reserved.

|  Sitemap  |   Legal  |   Privacy Policy  |   Disclaimer  |    Twitter  Facebook  YouTube  LinkedIn  RSS