Knowledgebase

Configure Patton SmartNodes with 3CX v20

(FXO and PRI)

�

Step 1: Create a �VoIP Gateway trunk� on 3CX

1. From the Admin panel, click on�Voice & Chat��and then on��Add Gateway�.
2. Specify a name.
3. Enter the gateway�s��Main Trunk Number�.
4. In��Registrar/Server�enter the SmartNode�s IP address.
5. Set the "Default Route".
6. Take note of the Authentication ID and password

��

7. Click on the �Options� tab and enter the �Number of sim calls per trunk� for this gateway. (This must not exceed the number of lines the gateway supports, e.g. a T1 gateway supports 23 lines.)
8. Click �Save� and the gateway is now configured in 3CX.
9. The last step is to create an Outbound Rule for this gateway. Once complete, click �Save�.

�

�

�

�

�

Step 2: Configure your SmartNode with 3CX

1. Run the configuration WEB WIZARD for your SmartNode device and fill in the required information.�

• Trinity FXO SmartNode WEB WIZARD�
• Trinity ISDN PRI SmartNode WEB WIZARD�
• SmartWare FXO SmartNode WEB WIZARD
• SmartWare ISDN SmartNode WEB WIZARD

�

2. Trinity FXO WEB WIZARD

• Fill in the following tabs of the web wizard

�

• Device Management Tab
  • Here you can change the default admin password.

�

�

• Network Settings Tab
  • Set the IP address as either DHCP client or a Static address.

�

• FXO Port Settings Tab
  • Select the number of FXO ports (1-8)
  • Select the country tone-set profile (United States and Europe)

�

�

�

• 3CX SIP Settings Tab
  • Server IP Address: Enter the IP/FQDN of 3CX
  • Set the Authentication ID and Password (This was previously configured in 3CX for this gateway)

�

�

�

• Once everything is filled out, you can select �Save� and the config file will be downloaded.

�

�

3. ISDN WEB WIZARD

• Fill in the following tabs of the web wizard

�

• Device Management Tab
  • Here you can change the default admin password.

��

�

• Network Settings Tab
  • Set the IP address as either DHCP client or a Static address.

�

�

�

�

• ISDN Port Settings Tab
  • Select the number of ISDN ports (1-4)
  • Select the PRI Line Type (E1 or T1)
  • Select what the ISDN port is connecting to (PBX or PSTN)
  • Select the country tone-set profile (United States and Europe)

�

�

�

• 3CX SIP Settings Tab
  • Server IP Address: Enter the IP/FQDN of 3CX
  • Set the Authentication ID and Password (This was previously configured in 3CX for this gateway)

�

�

�

• Once everything is filled out, you can select �Save� and the config file will be downloaded.

�

�

• Load in Config File
  • Enter the IP Address of the SmartNode into a web browser
  • Login using the default username and password of admin/<no password>
  • Click the top left-hand menu and navigate to �System/Configuration Files� and click the �+� button
  • Browse to the file generate and import in as the �startup-config� and click OK
  • Reboot the unit without saving

�

�

The unit should boot up and register to 3CX to make a receive calls.

�