Knowledgebase Article
| Knowledgebase > Unified Communications > SmartNode > SmartWare |
|
||
| What must be observed with codec selection with H.323 FastConnect procedure in case of overlap dialing? | |||
| Article Id #: 57 | |||
When using H.323 FastConnect (which is usually the case) together with overlap dialing the voice codec is sometimes not known to the B-side SmartNode in the route lookup. The configuration fragment below exemplifies how to configure a SmartNode such that it also accepts such incoming calls:
context cs
The bold section shows an H.323 interface without codec. This interface is used by the B-side SmartNode in case overlap dialling is used on the A-side and FastConnect is enabled. |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8829 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
