Knowledgebase Article
| Knowledgebase > Unified Communications > SmartNode > SmartWare |
|
||
| How do I debug QoS? | |||
| Article Id #: 62 | |||
Debugging QoS is different from any other debug commands. It is a two step process. You must be in configuration mode. 1) Go into your service policy and specify "debug queue statistics detail 7" 2) Then do a show command: "show service-policy interface eth0". You can repeat this command as often as you want to view the current statistics. |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8781 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
