Knowledgebase Article
| Knowledgebase > Unified Communications > SmartNode |
|
||
| Why does a command entered into the CLI does not appear in the 'show running-config'. | |||
| Article Id #: 80 | |||
If the command entered happens to be a default value (e.g. sntp-client poll-interval 60) the command is not displayed in the running-config but nevertheless active. This means that only commands and values other than defaults are displayed in the running-config. |
|||
| User Rating | |||
 This answer was helpful |
 This answer was not helpful |
(8836 vote(s))
|
|
| User Comments ( Add a Comment ) | |||
