Knowledgebase

 
 
Knowledgebase Article
Knowledgebase > Unified Communications


Activating the Configuration
Article Id #: 379

Changes made to the configuration of the SmartMedia units are stored on the OAM&P Configuration and Logging database. In order for changes to be used by the system, they must first be activated. This is done at the system level and accessed from the Navigation panel.

Note: To activate a configuration, you must be the Root user or have a user access level of 0.

To activate a system configuration:

1. Select Systems from the navigation panel.


Toolpack v2.5 Navigation Panel Systems.png

2. Click Edit next to the system you wish to activate,in order to access the System Configuration screen.


Toolpack v2.5 Edit System.png


3. Activate the configuration:

  • Enter a name for the system
  • Under Activate Configuration:
    • Select a Configuration on which to run the system
    • Click Activate

Note: Make certain that Lock Active Configuration box (located at the top of the page) is 'unchecked. Failure to do so will prevent the configuration from being saved.

Toolpack v2.5 Editing System.png

Verify that an activation confirmation message is displayed. The system will remind you to back up your database when you are done configuring (at top of screen, in yellow):


Toolpack v2.5 System Edited.png

User Rating
This answer was helpful This answer was not helpful (1782 vote(s)) 
User Comments  Add a Comment )

 
 
 
Sales: sales@patton.com / +1 301 975 1000
Support: support@patton.com / +1 301 975 1007
Join Our Email List
Have Us Contact You
or
Login Connect With Us
Twitter Linkedin Facebook Youtube
 
     Patton Electronics Co. Copyright © 2001–2020 All Rights Reserved.

|  Sitemap  |   Legal  |   Privacy Policy  |   Disclaimer  |    Twitter  Facebook  YouTube  LinkedIn  RSS