Knowledgebase

 
 
Knowledgebase Article
Knowledgebase > Unified Communications > SmartNode > SmartWare


My SmartNode can receive SIP via TCP but not send?
Article Id #: 456

By default, the SmartNode listens for both TCP and UDP traffic.  In order for the SmartNode to send SIP signaling using TCP, you will need to configure the following:

 

location-service SER_LYNC
  match-any-domain

  identity-group default

    call outbound
     preferred-transport-protocol tcp

    call inbound

context sip-gateway GW_SIP

  interface IF_GW_SIP
    bind interface eth0 context router port 5060

context sip-gateway GW_SIP
  bind location-service SER_LYNC
  no shutdown

 

For more information, please see the following article.

User Rating
This answer was helpful This answer was not helpful (278 vote(s)) 
User Comments  Add a Comment )

 
 
 
Sales: sales@patton.com
Direct: +1 301 975 1000
Support: support@patton.com
Direct: +1 301 975 1007
Have Us Contact You
or
Login Connect with us
Twitter Linkedin Facebook Youtube
 
     Copyright © 2001–2017 Patton Electronics Co., All Rights Reserved.

|  Sitemap  |   Legal  |   Privacy Policy  |   Disclaimer  |    Twitter  Facebook  YouTube  LinkedIn  RSS