Knowledgebase

 
 
Please also check out our Wizard Community Portal
 

Knowledgebase
Search Knowledgebase:  
 
Articles
>  Activating the Configuration
>  Austria 450Hz Style Tone Set
>  Calls disconnected after 32 sec
>  Create Line Interface
>  Create Line Service
>  Enabling Call Recording and Retrieve Recorded Files on SN10K
>  Fxs gateway in combination with Asterisk
>  How to configure a SmartNode FXS Gateway within 3CX?
>  How to protect my SmartNode from public netowrk attacks
>  IKE with AES-128 (Side #1)
>  Image.bin for SN4600 Series with BRI interfaces
>  Is it possible to configure different Point Codes for SS7 signaling and for voice traffic?
>  Manual Key Tunnel Mode with DES (Side # 1)
>  Manual Key Tunnel Mode with DES (Side # 2)
>  Mapping-Tables in the SmartNode 1k Series
>  SN - How a low bitrate codec is configured on SmartNodes?
>  SN10100 / SN10200 RJ45 Pinout
>  SN10k Route Retry theory and config
>  SN4118 FXS template for Cisco Call Manager, with authentication
>  SN411X/JS SIP terminal gateway template for Cisco Call Manager
>  SN46XX IP-PBX Gateway, SIP Trunk to ISDN PSTN
>  Tone definitions on SmartMedia
>  U-Boot factory config how to for SmartWare
>  VMWare ESXi and vSN - 'FAILED TO OPEN DEVICE' error message
>  What are the different Layer 1 states of the ISDN port?
>  What is the difference between a Gateway and a Gateway/Router?
>  What is the maximum size of the GTT Table in a SmartMedia SmartNode?
>  Which DHCP client options are supported in the SmartNode?
>  Why the SIP ACk message is not accepted by SN
>  Zoom Phone Configuration Wizard Templates
>  Zoom Phone Configuration Wizard Templates
 
 
Sales: sales@patton.com / +1 301 975 1000
Support: support@patton.com / +1 301 975 1007
Join Our Email List
Have Us Contact You
or
Login Connect With Us
Twitter Linkedin Facebook Youtube
 
     Patton LLC Copyright © 2022 All Rights Reserved.

|  Sitemap  |   Legal  |   Privacy Policy  |   Disclaimer  |    Twitter  Facebook  YouTube  LinkedIn  RSS