Patton - Support - Knowledgebase

Articles
> How do I start a debug session in the SmartNode
> T1 Configuration NETWORK
> What must be observed with codec selection with H.323 FastConnect procedure in case of overlap dialing?
> 8 Phone Distibution configuration
> Altigen H.323 SOHO Router
> Austria 420Hz Style Tone Set
> Austria 450Hz Style Tone Set
> Auto Provisioning with Timers and System MAC
> Avaya Open Office
> BroadVoice Long Distance FXS or FXO to PBX
> Bulgaria 1 Style Tone Set
> Bulgaria 2 Style Tone Set
> Bulgaria 3 Style Tone Set
> Calls disconnected after 32 sec
> Can I bind multiple SIP Gateways to the same IP Interface?
> Can I do encrypted VoIP calls with the SmartNode IPSec?
> Can I do VoIP over NAT (Network Address Translation)?
> CDR over Radius
> CDR over Radius different ports
> Changing PRI NP (Numbering Plan) and TON (Type of Number) to National/isdn-telephony
> Configuration for the SmartNode 4112 as a PSTN gateway in combination with a GFI Faxmaker
> Configuration for the SmartNode 4638 as a PSTN gateway in combination with a GFI Faxmaker
> Connect SmartNode to the LAN as a DHCP Client
> Connect SmartNode to the LAN via static IP addressing and a default gateway address
> Czech Republic Style Tone Set
> Day light time offset rule for Central Europe
> Debugging: SmartWare vs Trinity debug commands
> Dial up connection
> Distribution Group
> Do SmartNodes have a built-in NAPT application level gateway for H.323?
> Dynamic Domain Name Service; DynDNS
> Dynamic NAPT
> Dynamic NAPT with static Port Mappings
> E1 Port Configuration for DSS1
> Echo issue with SmartNode FXO ports
> Enable SmartNode as a DHCP Server
> Enable SmartNode as H.323 Gateway with GateKeeper
> Frame-Relay over Serial X.21/V.35 Port
> France Style Tone Set
> FXO Port configuration for US and Europe based application
> FXO To SIP TRUNK (with HUNT) Full configuration
> Fxs gateway in combination with Asterisk
> FXS Port Configuration
> General example configuration for INBOUND registrations, SIP registrar
> General example configuration for OUTBOUND registrations and authentication for a SIP trunk firmware 5.X
> General SIP outbound registrations example
> How can a FLASH be relayed from an FXS port to the PSTN on an FXO port?
> How can hosts behind the SmartNode be made accessible with Public IP addresses?
> How can I configure 3 party conference using SmartNode?
> How can I configure Daylight Savings on Smartnode Products
> How can I configure Smartnode E1 MFR2 for using carrier telefonica at Colombia?
> How can I connect with PPPoE to T-DSL (Germany) ?
> How can I do Call Transfer and FLASH codes on the SmartNode?
> How can I update a SmartNode 4552/4554 in redboot mode ?
> How can I update the SmartNode 1xxx /2xxx in bootloader mode ?
> How can I upgrade a SN4552 from 5.T to 5.1
> How do I configure the IGMP functionalities ?
> How do I debug QoS?
> How do I have to configure the SmartNode to work as Lync PSTN and Terminal Gateway
> How do I install a license key?
> How do I send a hook FLASH to a SIP Provider to use services like three-way conferencing?
> How do I use the ACL debugs to debug a VPN Connection?
> How does the gatekeeper registration work in detail?
> How does voice codec selection for H.323 work with SmartWare?
> How many VPN tunnels can I configure on a SmartNode?
> How to configure a SmartNode communicating with a SNMP-server
> How to configure a SmartNode FXS Gateway within 3CX?
> How to configure Mitel 3300 with Smartnode FXS port
> How to connect your Cyber-Data IP Paging equipment to Microsoft Lync
> How to debug a SmartNode using PuTTY?
> How to extend dial tone (dial tone extension) from one location to another location without a SIP server.
> How to protect my SmartNode from public netowrk attacks
> How to setup a Swyx IPPBX together with a SmartNode PSTN gateway
> How to setup ISDN UD-64 Data connection over VOIP
> How to use Timeout and Termination Characters in Call-Routing Tabels
> Hungary Stle Tone Sets
> Hunt Group configuration example
> IKE with AES-128 (Side #1)
> IKE with AES-128 (Side #2) Configuration
> Image.bin for SN4600 Series with BRI interfaces
> India Airtel and BSNL subscribers dial-tone
> Is DTMF supported in SmartWare?
> Is there a tool to convert SmartWare R2.20 configurations to R3.10 configurations?
> ISDN Trunk to SIP PBX Gateway configuration
> ISDN UD-64 Data connection over VOIP
> Italy Style Tone Set
> Japan-Style Tone Set
> Manual Key Tunnel Mode with DES (Side # 1)
> Manual Key Tunnel Mode with DES (Side # 2)
> Mapping-Tables in the SmartNode 1k Series
> Mexico Style Tone Set
> Multilink PPP, MLPPP, over 2 subscribers
> Multilink PPP, MLPPP, over one subscriber
> My SmartNode can receive SIP via TCP but not send?
> Netherlands Style Tone Set
> New Zealand-Style Tone Set
> Norway 1 Style Tone Set
> Norway 2 Style Tone Set
> Overflow handling, if input to SmartNode is higher than maximum output. Can the overflowing calls be sent via the fall-back ISDN-line?
> Patton IpChannelBank SmartNode 8-32 port FXS configuration with 3CX
> Poland Style Tone Sets
> Policy based IP routing configuration
> PPP over Serial X.21/ V.35
> PSTN and Terminal Gateway for e-Phone applications
> Russia Style Tone Sets
> SBC template for SN5XXX between VOIP provider and 2 Cisco Call Manager -Primary and Secondary-
> Slovenia Type Tone Sets
> SmartNode 1k Ethernet Port fallback enable port redundancy
> SmartNode 1K VPN using ISAKMP on Cisco ASA
> SmartNode ADSL PPPoA Port configuration
> SmartNode ADSL PPPoEoA Port configuration
> SmartNode and Hylafax/Asterisk Fax handling
> SmartNode Call Limiter configuration
> SmartNode configuration for use with OCS
> SmartNode E1 gateway - Asterisk IP-PBX with registration template
> SmartNode FXS gateway - Pingtel/sipX IP-PBX template
> SmartNode in combination with a CheckPoint� Firewall for Multimedia security
> SmartNode in combination with Skype
> SmartNode Napt traversal configuration
> SmartNode not Registering with 3CX - IP Blacklist and Whitelist
> SmartNode PPPoE Configuration
> SmartNode Priority Service configuration
> SmartNode PSTN trunk gateway for Asterisk IP-PBX
> SmartNode RTP Port Range
> SmartNode Second Dialtone Service configuration
> SmartNode SN-DTA with SIP Trunk and PSTN fallback
> SmartNode SN1X00 / SN4552 / SN46XX; Phone Gateway to a SIP network with PSTN Fallback and Emercency call routing
> SmartNode SN465X G.SHDSL connection with PPPoE
> SmartNode SN46x8 as Trunk Gateway SIP to PBX with Fallback
> SmartNode Static DynDNS Service configuration
> SmartNode Static NAT Address Mapping
> SmartNode T1 gateway - Asterisk IP-PBX with registration template
> SmartNode T1 gateway template not working with 3CX v14
> SmartNode T1 User Port Configuration
> SmartNode VLAN 802.1q on an Ethernet port
> SmartNode Voice Priority Configuration
> SmartWare 3.2x / 4.x SIP-gateway configuration
> SmartWare RADIUS Accounting "failure-action drop-call" behaviour
> SN - Example config for Voxbone inbound call service
> SN - How a low bitrate codec is configured on SmartNodes?
> SN - How can I remove or restricted Caller-ID (CLIP)?
> SN - Why do I have not CLIP in the ISDN setup message if an analogue device is connected through a terminal adapter?
> SN- Clip no screening
> SN4118 FXS template for Cisco Call Manager, with authentication
> SN411X/JS SIP terminal gateway template for Cisco Call Manager
> SN46xx as SIP-Trunk Gateway to ISDN-PBX with PSTN Fallback
> SN46XX IP-PBX Gateway, SIP Trunk to ISDN PSTN
> SN49XX PRI template for SIP Trunking Cisco Call Manager, with authentication
> SN49XX PRI template for SIP Trunking with 2 Cisco Call Manager-primary and secondary-, without authentication
> SN49XX PRI template for SIP Trunking with Cisco Call Manager, without authentication
> SNTP for Japan
> SNTP for Mexico
> South Africa Style Tone Sets
> Spain Style Tone Set
> Sri Lanka Type Tone Sets
> Stacking SmartNode`s
> Swedish Style Tone Set
> T1 Loopback plug for testing both Line and CSU/DSU
> The License does not work correctly on my SmartNode 4000 Series?
> U-Boot factory config how to for SmartWare
> UK Style Tone Set
> USA-Style Tone Set
> What are the available Voice Codecs?
> What are the different Layer 1 states of the ISDN port?
> What does Call quality log contain and how will it be configured
> What happens if I do not install License Keys after the upgrade from Release 2.20 to 3.10?
> What happens if the software upgrade on a SmartNode fails?
> What is MFC-R2?
> What is the problem, when VoIP Signaling works fine but there is no voice at all?
> When do I need ISDN line power?
> When installing the License the SmartNode returns an error
> Where can I get a TFTP Server to load my configuration or upgrade my SmartNode Software?
> Which DHCP client options are supported in the SmartNode?
> Which SmartNode CLI commands are not supported with the timer function
> Which SmartNodes are interoperable with Microsoft Lync?
> Why am getting a "503 Service Unavailable� SIP message when sending a SIP call to the SN?
> Why do I hear a crackling noise when using the G.729 codec?
> Why do I need a License Key for Release 3.10?
> Why does Keypad facility messages not work with H.323?
> Why does the routes on my MS Windows machines change when a SmartNode is booted on the same subnet.
> Why does the Siemens Hipath PBX not show the Caller-Name with Qsig as signaling protocol
> Why is my defined tone not played correctly? How many custom tones can be configured?
> Why is the DES/3DES VPN encryption Key, displayed in the running-config, different to my input?
> Why the RTP traffic does not pass the ACL
> Why the SIP ACk message is not accepted by SN

Sender Email Address:

Subject:

Message:

Join Our Email List

Have Us Contact You
	or

Login	Connect With Us